Amigo 4WD V6-3.2L (1999)
Malfunction Indicator Lamp - A/T: Testing and Inspection
Find CHECK TRANS indicator and verify if it is:
A. Flashing: GO TO DIAGNOSTIC CHECK.
B. Staying on: GO THROUGH "CHECK TRANS" CHECK.
C. Is never ON when the ignition key is turned on: GO THROUGH CHECK TRANS CHECK
D. Is ON during 2 to 3 seconds at ignition but OFF after: Normal operation. No DTC or malfunction.
DIAGNOSTIC CHECK
This test determines if the transmission or its input, or output, connections, or sensors are failing.
1. Connect the TECH-2: GOTHROUGH TECH-2 OBD II CONNECTION.
2. Turn on the ignition but not the engine.
3. Push "F2" on TECH-2 to see the Diagnostic Trouble Code (DTC):
4. Do you have a DTC?
YES: write down all code numbers and do the DTC CHECK
NO: the DTC can not help you find the problem.
1. GOTHROUGH "CHECK TRANS" CHECK
2. IF it is flashing and the flash is 0.2 seconds ON and 0.2 seconds OFF, this means that you should have a DTC stored. Please recheck
GOTO DIAGNOSTIC CHECK and if you find the same problem, replace the Powertrain Control Module (PCM).
"CHECK TRANS" CHECK
Normal
1. Indicator is ON during 2 to 3 seconds at ignition (or when the engine is cranked) but it is OFF after the engine starts. The indicator is working
normally.