Amigo 4WD V6-3.2L (1999)
3. Move one end of the spider to cause a trunnion to project through the spider hole beyond the outer machined face of the yoke lug. Place a bearing
over the trunnion diameter and align it to the spider hole. Using an arbor press, hold the trunnion in alignment with the spider hole and place a
solid plug on the upper bearing. Press the bearing into the spider hole enough to install a snap ring.
4. Install a snap ring. Be sure the snap rings are properly seated in the grooves.
5. Repeat steps 3 and 4 to install the opposite bearing. If the joint is stiff, strike the yoke ears with a soft hammer to seat needle bearings.
6. Align setting marks (1) and join the yokes.
7. Install snap ring.
UNIVERSAL JOINT REASSEMBLY (DOUBLE CARDAN TYPE)
1. Pack the four grease cavities of the cross with a high quality, extreme pressure N.L.G.I. Grade 2 grease. Do not add additional grease to bearing
cup assembly.
2. Fit a cross into the tube yoke.
