Amigo 4WD V6-3.2L (1999)
3. Move an end of the cross to cause a trunnion to project through the cross hole beyond the outer machined face of the yoke lug. Place a bearing cup
assembly over the trunnion diameter and align it to the cross hole. Using an arbor press, hold the trunnion in alignment with the cross hole and
place a solid plug on the upper bearing cup assembly. Press the bearing cup assembly into the cross hole enough to install a snap ring.
4. Install a snap ring.
5. Repeat steps 3 and 4 to install the opposite bearing cup assembly. If the joint is stiff, strike the yoke ears with a soft hammer to seat the needle
bearing.
NOTE: Be sure the snap rings are properly seated in the grooves.
6. Fit the center yoke ("H" Yoke) on the remaining two trunnions and press bearing assemblies in place, both sides as in steps 3 and 4 above. Install
snap rings.
7. Install the journal onto the flange as per steps 3 and 4 above.