Ascender 2WD L6-4.2L (2003)
6.
Using a large flat-bladed tool, rock the striker up and down in order to loosen the striker backing plate from the body (see figure 2).
7.
Close the door while holding the outside handle in the open position in order to align the lock striker. If necessary, adjust the striker position in
order to allow the door to close with minimum effort.
NOTE:
Do not slam the door.
8.
Finish by tightening the lock striker screws to 25 N.m (18 lb ft).
Warranty Claim Information
Use the labor operation shown.
Labor Time includes administrative time allowance.
Disclaimer
Technical Service Bulletin # SB07-11-S003
Date: 070401
Body - Doors are Hard to Close
2007 Service Bulletins
TSB SB07-11-S003
Issue Date: APRIL 2007
