Ascender 2WD L6-4.2L (2003)
6. Remove the connector position assurance (CPA) (3) from the side impact sensor yellow 2-way connector (5) located near the bottom left of the
door.
7. Disconnect the side impact sensor yellow 2-way connector (5) located near the bottom left of the door.
Enabling Procedure
1. Remove the key from the ignition.
2. Connect the side impact sensor yellow 2-way connector (5) located near the bottom left of the door.
3. Install the CPA (3) to the side impact sensor yellow 2-way connector (5) located near the bottom left of the door.
4. Install the LF door trim panel.