Ascender 2WD V8-5.3L (2004)
7.
Tighten the lock striker screws that retain the lock striker to the door opening.
8.
Tighten the lock striker screws only until the screw heads are flush to the lock striker plate, but still allowing the striker to move.
9.
Using a large flat-bladed tool, rock the striker up and down in order to loosen the striker backing plate from the body.
IMPORTANT:
Do not slam the door.
10.
Close the door while holding the outside handle in the open position in order to align the lock striker. If necessary, adjust the striker position in
order to allow the door to close with minimum effort.
11.
Open the door.
12.
Finish tightening the lock striker screws.
Tighten
Tighten the lock striker screws to 25 Nm (18 lb ft).
13. Verify proper door operation.
Warranty Claim Information
Always refer to the Isuzu Service Policy Procedure Manual for specific details on warranty coverage
and policies. Reference published Labor Time Guide for claim processing, if applicable.
Disclaimer
