Ascender 2WD V8-5.3L (2004)
MY and prior) or Exterior Trim sub-section of the Service Manual. Modify the tightening sequence for the screws that retain the pocket assembly
to the liftgate as follows:
^
Push the entire rear license plate pocket assembly upward in the opening of the liftgate. Inspect the perimeter gasket to see if it is properly
retained.
Tighten
Tighten the rear license plate pocket assembly retaining nuts to 5 Nm (44 lb in) in the following order.
^
Tighten the upper left retaining nut first.
^
Tighten the upper right retaining nut second.
^
Tighten the three lower retaining nuts in any order.
Parts Information
Always refer to AIPDN publications for the most current parts information.
Warranty Claim Information
Always refer to the Isuzu Service Policy Procedure Manual for specific details on warranty coverage and policies. Reference published Labor Time
Guide for claim processing if applicable.
Disclaimer
