Ascender 2WD V8-5.3L (2004)
19. Select Next.
20. The Transfer Data screen will appear until the progress bar reaches 100 percent. This may take up to 30 minutes.
21. Complete all of the terminal-directed data on the Programming Complete screen.
Important:
Some vehicles will require that Idle Learn, Theft Deterrent Relearn, or Crankshaft Variation Learn procedures be performed after
programming. Consult the appropriate service information for these procedures.
22. Turn OFF the Tech 2.
23. Disconnect the Tech 2 from the vehicle.
Remote Programming
Service Programming System (SPS) Off Board Remote Procedure
Tools Required:
J 41207-C Off-Board Programming Adapter Kit
The J 41207-C is required when a module must be programmed without having the vehicle present. The adapter allows the module to be turned ON and
communicate with the scan tool.
For additional SPS information, refer to Service Programming System (SPS) Description.
Important:
Ensure the Tech 2 and the terminal are both equipped with the latest software before performing SPS.
Performing the Off Board Remote Procedure
1. Obtain the vehicle identification number (VIN) of the vehicle for which the module is being programmed.
Important:
The TIS supports service programming with the Tech 2 scan tool only.
2. Launch the TIS application at the terminal.
3. Select the Service Programming System.
4. Highlight the following information on the Select Diagnostic Tool and Programming Process screen:
*
Select Diagnostic Tool-Select Tech 2
*
Select Programming Process-Identify whether an existing module is being reprogrammed or replaced with a new one.
*
Select ECU location-select Off-Board Programming Adapter.
5. Select Next.
Important:
Ensure the correct connector for the control module is used.
6. Follow the directions on the Preparing for Communication screen for connecting the following components:
*
The control module
*
The Off-Board Programming Adapter (OBPA)--Refer to the TIS Users Guide for a listing of the OBPA.
*
The Tech 2
7. Select the Service Programming Request Information function on the Tech 2.
8. Follow the Tech 2 instructions to obtain the module data and security information.
9. After the Tech 2 has received the data from the module, exit the Request Info mode.
10. Disconnect the Tech 2 from the OBPA.
11. Turn OFF the Tech 2.
12. Connect the Tech 2 to the terminal.
13. Turn ON the Tech 2.
14. Select Next at the terminal after the Tech 2 start-up screen appears.
15. Enter the VIN of the vehicle that will be receiving the control module.
16. Select Next.
Important:
When selecting the vehicle configuration index (VCI) programming type, a valid VCI number for the vehicle must be entered. This
number may be obtained from Techline Customer Support.
17. Select the type of programming to be performed from the following categories:
*
Normal--Used for updating an existing calibration or programming a new controller.
*
Vehicle configuration index (VCI)--Used for updating an existing controller or programming a new controller for newer vehicles whose VINs
are not yet in the database.
*
Reconfigure--Used to reconfigure a vehicle for changes in tire size and axle ratios.
18. Select Next.
19. Select a calibration on the Calibration Selection screen, if necessary.
