Ascender 2WD V8-5.3L (2004)
9. Install the stabilizer shaft link retaining nut.
^
Tighten the nut to 100 Nm (74 ft. lbs.).
10. Install the outer tie rod to the steering knuckle.
11. Install the outer tie rod retaining nut.
^
Tighten the nuts to 45 Nm (33 ft. lbs.).
12. Install the tire and wheel.
13. Lower the vehicle.
14. Check the front wheel alignment.
Upper Control Arm
Upper Control Arm Replacement
Removal Procedure
1. Raise and support the vehicle.
2. Remove the tire and wheel.
3. Remove the upper ball joint to upper control arm pinch bolt and nut.
