Ascender 2WD V8-5.3L (2004)
7. Remove the rear axle upper control arm.
Installation Procedure
1. Install the rear axle upper control arm.
2. Install the rear axle upper control arm to frame mounting bolt.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the rear axle upper control arm to axle mounting nut and bolt.
^
Tighten the rear axle upper control arm mounting bolts to 130.5 Nm (96 ft. lbs.).
4. If equipped with air suspension, connect the air suspension leveling sensor link to the rear axle upper control arm.
5. Remove the rear axle support.
6. Install the wheelhouse panel.
7. Install the tire and wheel.
