Ascender 4WD V8-5.3L (2004)
13. Disconnect the console harness connector from the junction block.
14. Remove the block base retaining nuts from the floor studs.
15. Remove the block base from the floor panel.
Installation Procedure
1. Install the block base to the floor studs.
NOTE: Refer to Fastener Notice in Cautions and Notices.
2. Install the block base retaining nuts to the floor studs.
Tighten:
Tighten the block base retaining nuts to 10 N m (88 lb in).
3. Connect the console harness connector to the block base.
4. Connect the headliner harness connector (2) to the block base.
5. Connect the body wiring harness connector (1) to the block base.
