Axiom 2WD V6-3.5L (2002)
3. Set push rod gauge J-39216 on vacuum booster, and apply negative pressure by means of vacuum pump J-23738-A so that the pressure in the
vacuum booster becomes 500 mm Hg.
Note: Be sure to apply NEGATIVE pressure after installing a push rod gauge on the vacuum booster.
4. Measure dimension (4).
Dimension (4) (Standard): -0.1 - 0.1 mm (-0.0039 - 0.0039 inch)
5. If dimension (4) is out of the standard range, adjust push rod using the Push Rod Support J-39241.
6. Mount plate and seal assembly in vacuum booster front shell. Then install the retainer.
7. Install vacuum booster fixing nut and tighten the specified torque.
Torque: 15 Nm (11 ft. lbs.)
8. Install yoke clevis.
9. Connect vacuum hose and make sure that the arrow on the hose points in the direction of the engine.
10. Install master cylinder.