Axiom 2WD V6-3.5L (2002)
Installation
1. Install the combination switch assembly with SRS coil (9).
2. Connect the wiring harness connectors (10) located at the base of steering column.
3. Turn the SRS coil clockwise to full, return about 3 turns and align the neutral mark.
NOTE: Whenever installing the new combination switch with SRS coil, be sure to tear off the lock pin for aligning the neutral position before it
is installed to the base of steering column.
CAUTION: When turning the SRS coil clockwise to full, stop turning if resistance is felt. Forced further turning may damage the cable in the
SRS coil.
4. Install the steering column cover (3).
CAUTION: When installing the steering column cover, be sure to through each harness as illustrated so that the harnesses starter switch,
combination switch and SRS coil may not catch wiring.
5. Install the driver knee bolster assembly.
6. Install the steering lower cover.
7. Install the steering wheel and align the setting marks (4).
8. Tighten the steering wheel fixing nut (5) to the specified torque.
Torque: 34 N.m (25 lb ft)
9. Connect horn lead (1).
10. Connect air bag to wiring harness connector (2).
NOTE: Pass the lead wire through the tabs on the plastic cover (wire protector) of air bag to prevent lead wire from being pinched.
11. Install Air Bag (6) into steering wheel and tighten bolts (8) to specified sequence as figure.
Torque: 8.8 N.m (78 lb in)
CAUTION: Never use the air bag assembly from another vehicle and difference model year air bag assembly.
The air bag assembly has identification colors on the bar code label as follows.
-
Light blue color for driver air bag assembly.
-
Light blue color for passenger air bag assembly.
Use only the air bag assembly for "UP".
12. Enable the SRS. Refer to Enabling the SRS in this section.
