Axiom 2WD V6-3.5L (2002)
13. Remove the combination switch assembly with SRS coil (9).
NOTE: SRS coil is a part of combination switch assembly, which cannot be replaced separately. Therefore, be sure not to remove the SRS coil
from the combination switch assembly.
14. Remove the snap ring.
15. Remove the cushion rubber.
16. Disconnect shift lock cable (A/T only)
17. Disconnect the starter switch harness connector (12) located base of steering column.
18. Remove steering lock cylinder assembly (11).
19. Remove steering column assembly (13).
Installation
1. Install the steering column assembly (13) and align the setting marks on the universal joint and steering shaft made during removal.
2. Tighten the steering column fixing bolts (dash panel side) to the specified torque.
Torque: 20 N.m (14 lb ft)
3. Tighten the steering column fixing nuts (Cross beam) to the specified torque.
Torque: 20 N.m (14 lb ft)
4. Tighten the universal joint to the specified torque.
Torque: 31 N.m (23 lb ft)
5. Install steering lock cylinder assembly (11).
6. Connect shift lock cable (For A/T)
7. Install cushion rubber.
8. Install snap ring.
9. Install the combination switch assembly with SRS coil (9).
10. Connect the wiring harness connector (10) located on the base of steering column.
11. Turn the SRS coil clockwise to full, return about 3 turns and align the neutral mark.
CAUTION: When turning the SRS coil clockwise to full, stop turning if resistance is felt. Further forced turning may damage the cable in the
SRS coil.
