Axiom 2WD V6-3.5L (2002)
13. Remove the combination switch assembly with SRS coil.
14. Remove snap ring.
15. Remove cushion rubber.
16. Remove shift lock cable (for A/T).
17. Disconnect the starter switch harness connector located under the steering column then remove lock cylinder assembly.
Installation
1. Install lock cylinder assembly.
2. Install shift lock cable (for A/T).
3. Install cushion rubber.
4. Install snap ring.
5. Install Combination switch and SRS coil assembly. After installation of combination switch assembly, connect the combination switch wiring
harness connector and the SRS 2-way connector located under the steering column.
6. Turn the SRS coil counter clockwise to full, return about 3 turns and align the neutral mark.
Caution: Turn the SRS coil counter clockwise until some resistance is felt, or damage may occur to the SRS coil.
