Axiom 2WD V6-3.5L (2002)
Power Steering Pump: Service and Repair
Removal and Installation
Removal
1. Remove the drive belt.
2. Place a drain pan below the pump.
3. Disconnect the suction hose.
4. Disconnect the flexible hose.
5. Remove the power steering fixing bolt and remove the pump assembly.
Installation
1. Install the pump assembly to the pump bracket tighten the fixing bolt to the specified torque.
Torque: 46 Nm (34 ft. lbs.)
2. Install the flexible hose. Tighten the eye bolt to specified torque.
Torque: 54 Nm (40 ft. lbs.)
3. Install the drive belt.
4. Connect the suction hose, then fill and bleed system.
