Axiom 2WD V6-3.5L (2002)
Stabilizer Bar: Service and Repair
Rear Suspension
Removal
1. Raise the vehicle and support the frame with suitable safety stands.
2. Remove wheel and tire assembly.
3. Remove bolt and nut.
4. Remove link.
5. Remove bracket.
6. Remove rubber bushing.
Inspection and Repair
Make necessary correction or parts replacement if wear, damage, corrosion or any other abnormal condition are found through inspection.
Check the following parts:
^
Stabilizer bar
^
Rubber bushing
^
Link
Installation
1. Install rubber bushing.
2. Install bracket to axle housing and tighten to the specified torque.
Torque: 25 Nm (19 ft. lbs.)
3. Install link.
