Axiom 2WD V6-3.5L (2002)
1. Install wheel pin.
-
Place hub on a wood workbench or a block of wood approximately 6" by 6" to protect the wheel stud ends and threads.
-
Install wheel stud, using a hammer.
Note: Be sure wheel stud is started squarely and seats completely.
2. Install the hub unit bearing to the knuckle.
Tighten the bolts to the specified torque.
Hub unit bearing bolt
Torque: 103 +/-10 Nm (10.5 +/-1 kg m)
If there is rust on the bearing and knuckle contact surfaces, use sandpaper to remove it before installation.
3. Install the AB sensor connector.
4. Install the disc rotor.
5. Install the brake caliper to the bracket.