Axiom 2WD V6-3.5L (2002)
Transmission Speed Sensor: Service and Repair
Speed Sensor (Extension Assembly)
Removal
1. Raise the vehicle and support on jack stands.
2. Disconnect battery ground cable.
3. Disconnect speed sensor harness connector from speed sensor.
4. Remove one 10 mm screw and speed sensor with O-ring.
Sensor Location (4x4)
Sensor Location (4x2)
Installation
1. Inspect the speed sensor O-ring, and replace it if necessary.
2. Install speed sensor assembly and 10 mm screw.
Torque: 9 Nm (78 inch lbs.)
3. Connect speed sensor harness connector to speed sensor.
4. Connect battery ground cable.