Axiom 2WD V6-3.5L (2002)
Wiper Motor: Service and Repair
Rear Wiper Motor
Rear Wiper Motor
Removal
1. Disconnect the battery ground cable.
2. Remove the tailgate trim pad.
-
Refer to Tailgate in Body Structure section.
3. Remove the wiper arm/blade. Refer to Rear Wiper Arm/Blade in this section.
4. Remove the rear wiper motor (1).
-
Disconnect the connector.
-
Remove the rear wiper motor fixing screws.
Installation
To install, follow the removal steps in the reverse order, noting the following points:
1. Before installing the wiper arm/blade (1) to the motor shaft (6), confirm that the motor stops at the autostop position.
2. Tighten the motor shaft nut (5) to the specified torque.
Torque: 10 N.m (87 lb in)
3. Tighten the wiper arm nut (3) to the specified torque.
Torque: 9 N.m (78 lb in)