Hombre S Regular Cab 2WD L4-2.2L CPC (1998)
5. Measure the clearance between the caliper and the steering knuckle.
5.1.Measure each end of the caliper individually and add the two measurements together.
5.2.The total measurement should be 0.26 - 0.60 mm (0.010 - 0.024 inch).
6. Install the tire and wheel assembly. Refer to Tire and Wheel Installation in Tires and Wheels.
7. Lower the vehicle and remove the safety stands.
IMPORTANT: Before moving the vehicle, pump the brake pedal several times in order to make sure the pedal is firm. Do not move the vehicle
until you get a firm brake pedal. Check the brake fluid level in the master cylinder reservoir after pumping the brake pedal.
Inspection
INSPECTION PROCEDURE
1. Inspect the mounting bolts and sleeves for corrosion. Do not polish away any corrosion.
2. Replace corroded mounting bolts and sleeves.
Disassembly and Reassembly
DISASSEMBLY PROCEDURE
1. Drain all the brake fluid from the caliper.
CAUTION: Do not place your fingers In front of the piston In order to catch or protect the piston while applying compressed air. This could
result In serious injury.
NOTICE: Use just enough air pressure to ease the piston out of the bore. You can damage a blown-out piston even with the padding.
2. Pad the interior of the caliper with clean shop towels.
3. Remove the piston from the caliper bore.
4. Remove the boot from the caliper bore. Do not scratch the housing bore.
