Hombre S Regular Cab 2WD L4-2.2L CPC (1998)
2. Remove the tire and wheel.
3. Remove the anchor bracket bolts.
4. Remove the assembled anchor bracket and caliper from the mounting plate.
5. Hang the assembled anchor bracket and caliper from the suspension.
6. Remove the rotor. Slowly turn the rotor while pulling the rotor away from the axle.
INSTALLATION PROCEDURE
NOTICE: Whenever the rotor has been separated from the axle flange, clean any rust or foreign material from the mating surface of the axle
flange and brake rotor. Failure to do this may result in increased lateral runout of the rotor and brake pulsation.
1. Install the rotor.
2. Install the assembled anchor bracket and caliper to the mounting plate.
Tighten
Tighten the anchor bracket bolts to 70 Nm (52 ft. lbs.).
3. Install the tire and wheel.
4. Lower the vehicle.
