Hombre S Regular Cab 2WD L4-2.2L CPC (1998)
Parking Brake Shoe: Service and Repair
REMOVAL PROCEDURE
1. Raise the vehicle.
2. Support the vehicle with safety stands.
3. Remove the wheel and the tire.
4. Remove the caliper. Refer to Brake Caliper Replacement (Front Wheel) or Brake Caliper Replacement (Rear Wheel).
5. Remove the rotor. Refer to Brake Rotor Replacement (Front Wheel) or Brake Rotor Replacement (Rear Wheel).
6. Remove the park brake cable from the park brake lever.
7. Remove the park brake shoe assembly by sliding the shoe towards the hold down spring until the shoe is disengaged from the spring.
8. Remove the shoe from the actuation mechanism.
9. Clean the debris and the dust from the park brake components using a clean towel.
10. Turn the adjustment screw to the fully home position in the notched adjustment nut, then back it off 1/4 turn.
11. Align the slots in both the adjusting screw and tappet to be parallel with the backing plate face.
INSTALLATION PROCEDURE
1. Install a new park brake shoe.
2. Position the shoe on the inboard side of the actuation mechanism.
3. Clip the shoe on the hold down spring.
4. Inspect the shoe assembly position. The shoe must be central on the backing plate and with both tips located in the slots.
5. Manually check the park brake for proper operation.
6. Install the park brake cable to the park brake lever.
7. Adjust the park brake shoe. Refer to Park Brake Cable Service / Adjustment.
8. Install the caliper. Refer to Brake Caliper Inspection (Front Wheel) or Brake Caliper Inspection (Rear Wheel).
9. Install the rotor. Refer to Brake Rotor Replacement (Front Wheel) or Brake Rotor Replacement (Rear Wheel).
10. Install the tire and wheel.
11. Lower the vehicle.
