Hombre S Regular Cab 2WD L4-2.2L CPC (1998)
Removing Pulley Rotor And Bearing Assembly
Remove or Disconnect
1. Install the compressor assembly onto the J 41790.
2. Remove the clutch plate and hub assembly (2). Refer to "Compressor Clutch Plate and Hub Assembly Removal".
3. Remove the clutch rotor and bearing assembly retaining ring (3), using external snap ring pliers (1).
4. Place the J 33023-A on the clutch rotor.
5. Install the J 41552 down into the inner circle of slots in the rotor.
-
Turn the compressor pulley puller clockwise in the slots to engage the puller tangs with the rotor.
6. Hold the compressor pulley puller in place and use a wrench to turn the center forcing screw against the puller pilot to remove the clutch rotor and
bearing assembly.
Installing Pulley Rotor And Bearing Assembly
