Hombre S Regular Cab 2WD L4-2.2L CPC (1998)
Air Bag(s) Arming and Disarming: Service and Repair
SRS Service Precautions
Caution: When you are performing service on or near the SR8 components or the SRS wiring, you must disable the SRS system. Use the following
procedure to temporarily disable the SRS. Failure to follow the correct procedure could cause air bag deployment, personal injury, or unnecessary SRS
repairs.
The supplemental restraint Sensing and Diagnostic Module (SDM) maintains a reserve energy supply. Ignition voltage can provide deployment energy it
the 23 Volt Loop Reserve malfunction. Deployment power is available for as much as 10 minutes after disconnecting the vehicle power by any of the
following methods:
- You turn the ignition switch to the OFF position.
- You remove the fuse that provides power to the 5DM.
- You disconnect the vehicle battery from the vehicle electrical system.
Performing the following procedure prevents deploying of the air bags from the reserve energy supply power.
Disabling the SRS
1. Turn the steering wheel so that the vehicle's wheels are pointing straight ahead.
2. Turn the ignition switch to the LOCK position.
3. Remove the key from the ignition switch.
Important: With the SIR Fuse removed and the ignition switch in the RUN position, The AIR BAG warning lamp illuminates. This is normal
operation, and does not indicate an SRS malfunction.
4. Remove the SIR Fuse from the IP fuse block.
5. Remove the sound insulator-LH (if equipped).
6. Remove the knee bolster.
7. Remove the Connector Position Assurance (CPA) from the driver yellow 2-way connector located at the base of the steering column.
