Hombre S Regular Cab 2WD L4-2.2L CPC (1998)
Air Bag Warning Lamp: Testing and Inspection
Warning Lamp Does Not Come "ON"
Airbag Warning Lamp Does Not Come On
Circuit Description
When the ignition switch is first turned to RUN, the GAUGES Fuse applies battery voltage to the AIR BAG warning lamp that is connected to Air Bag
Indicator Control, terminal 7. The SIR Fuse applies battery voltage to the IGNITION 1 input, terminal 10. The supplemental restraint Sensing and
Diagnostic Module (SDM) responds by flashing the AIR BAG warning lamp seven times.
When measurements are requested in this table, use J 39200 Digital Multimeter with the correct terminal adapter from J 35616-A Connector Test
Adapter Kit. When a check for proper connection is requested, refer to Intermittents and Poor Connections See: Testing and Inspection/Initial Inspection
and Diagnostic Overview/Troubleshooting Intermittent Failures. When a wire, connector or terminal repair is requested, use J 38125-A Terminal Repair
Kit.
