Hombre S Regular Cab 2WD L4-2.2L CPC (1998)
3. Key alarm switch from module assembly (15).
-
Gently pry retaining clip on alarm switch with small blade screwdriver.
-
Rotate alarm switch 1/4 turn and remove.
-
Remove passkey connector.
4. Ignition & key alarm switch assembly (19).
-
Use small screwdriver to push on slots to remove ignition & key alarm assembly.
-
Let switch (19) hang freely.
NOTICE: Lock bolt assembly (11) is under slight spring tension from lock bolt spring (12). Hold lock bolt (11) in place while removing lock module
assembly (15).
5. Three pan head tapping screws (13).
6. Lock module assembly (15).
7. Lock bolt assembly (11) with lock bolt spring (12).
-
Spring (12) from lock bolt (11).
8. Remove lock cylinder set.
Install or Connect
NOTICE: Refer to the fastener precautions NOTICE. See: Service Precautions/Technician Safety Information Failure to do so may result in component
damage or malfunction of steering column.
Removing Lock Module Assembly
1. Lock cylinder set.
-
Turn lock cylinder to "LOCK" position.
2. Lock bolt assembly (11) with lock bolt spring (12).
-
Ensure cutout in lock bolt (11) is in the 6 o'clock position.
3. Lock module assembly (15).
-
Push lock bolt (11) into steering column housing assembly (26) until flush.
-
Align lock module assembly (15) with housing assembly (26) and install.
4. Three pan head tapping screws (13). Tighten screws (13) to 7 N.m (62 lb.in.)
