Hombre S Regular Cab 2WD L4-2.2L CPC (1998)
Power Steering Gear-Legend 2 Of 2
REMOVE OR DISCONNECT
-
Steering gear from vehicle.
-
Pitman arm from steering gear.
-
Rotate stub shaft back and forth to drain power steering fluid.
CLEAN
-
Exposed end of pitman shaft and housing.
-
Use a wire brush to clean pitman shaft spline.
DISASSEMBLE
1. Adjuster lock nut (8). Bolts (10).
2. Rotate stub shaft (40), using a 1 2-point socket, to center gear.
3. Side cover (7), gasket (1 1), and pitman shaft (12) as an assembly.
4. Pitman shaft (12) from the side cover (7).
ASSEMBLE
1. Pitman shaft (12) to side cover (7) by screwing postman shaft (12) in until it fully seats to side cover (7)
2. Adjuster lock nut (8).
-
Do not tighten adjuster lock nut (8) until after pitman shaft adjustment has been made.
3. Gasket (11) to side cover (7) and bend tabs around edges of side cover (7).
4. Pitman shaft assembly and side cover (7) to housing (20).
5. Bolts (10).
TIGHTEN
-
Bolts (10) to 60 Nm (44 ft. lbs.).
ADJUST
-
Pitman shaft.
INSTALL OR CONNECT
-
Steering gear.
Housing End Plug Replacement
