Hombre S Regular Cab 2WD L4-2.2L CPC (1998)
5. Remove the following parts:
-
The upper shackle bolt
-
The nut
-
The flat washers
6. Loosen the lower shackle bolt at the spring. Leave the bolt attached.
7. Lower the axle until there is enough clearance to remove the shackle bushing.
8. Use a blunt punch to straighten out the bushing flange that comes through the inner frame.
IMPORTANT: Replace both of the shackle bushings while the fuel tank is off the vehicle.
9. Remove the shackle bushing using J21474-01 or equivalent.
INSTALLATION PROCEDURE
Tools Required
J21474-01 or equivalent Control Arm Bushing Service Set
1. Install the shackle bushing. A new shackle bushing must be used. Use the tools as shown.
2. Pull the bushing into the frame rail until the flanged portion of the bushing is flush with the rail.
3. Stake the shackle bushing inner flange.
4. Raise the axle into position.