Hombre S Regular Cab 2WD L4-2.2L CPC (1998)
4. In order to swage the swage clamp, position the inboard end (1) of the halfshaft assembly in the J41048.
5. Align the swage clamp (2) within J41048.
6. Place the top half of the J41048 on the bottom half.
7. Place the top half of the J41048 on the bottom half.
8. Check to make sure there are no pinch points on the seal before proceeding with procedures.
9. Insert the bolts (2).
10. Tighten the bolts (2) by hand until snug. Tighten Each bolt 180 degrees at a time, using a ratchet wrench. Alternate between each bolt until both
sides are bottomed.
11. Align the following items:
-
The seal
-
The housing
-
The swage clamp
12. Loosen the bolts. Separate the dies.
13. Check the swage clamp for any 'flip', deformities. If deformities exist, place the swage clamp back into the J41048. Make sure the swage clamp
covers the whole serrating area.
Re-swage the swage clamp.