Hombre S Regular Cab 2WD L4-2.2L CPC (1998)
14. Install the convolute retainer over the seal, being sure to capture four convolutions.
Important: Assemble the joint with the convolute retainer in the correct position. The seal will be damaged if the joint is not assembled to meet
the specified dimension.
15. Install the spacer ring (2) and spider assembly (1) onto the axle shaft (3).
16. Install the other spacer ring in the groove at the end of the axle shaft. Ensure that the rings are fully seated.
17. Pack the seal and housing with the grease supplied in the kit. The amount of grease supplied in this kit has been pre-measured for this application.
18. Place the large retaining clamp (2) on the seal
19. Now place the housing (1) and bushing over the spider assembly (3).
20. Install the seal onto the tripot bushing.
