Hombre S Regular Cab 2WD L4-2.2L CPC (1998)
Seals and Gaskets: Service and Repair
REMOVAL PROCEDURE
1. Raise the vehicle.
2. Remove the transmission oil. Refer to Fluid Replacement.
3. Remove the propeller shaft. Refer to Two-Piece Propeller Shaft Replacement or Three-Piece Propeller Shaft Replacement.
4. Remove the parking brake, if the vehicle is equipped. Refer to Backing Plate Replacement.
5. Remove the yoke nut and washers.
6. Remove the yoke.
7. Remove the extension oil seal.
INSTALLATION PROCEDURE
-
Tools Required
-
J22834 Extension Housing Seal Installer
1. Install a new extension oil seal. Use the J122834.
2. Install the yoke.
3. Install the washers and yoke nut.
Notice: Refer to Fastener Notice in Service Precautions.
Tighten the yoke nut to 441 Nm (325 ft. lbs.).
4. Install the parking brake, if the vehicle is equipped. Refer to Backing Plate Replacement.
5. Install the propeller shaft. Refer to Two-Piece Propeller Shaft Replacement or Three-Piece Propeller Shaft Replacement.
6. Replace the transmission oil. Refer to Fluid Replacement.
7. Lower the vehicle.
