Hombre S Space Cab 2WD V6-4.3L (2000)
2. Install the four EBCM bolts.
Tighten
Tighten the four bolts to 5 Nm (39 inch lbs.) in an X-pattern.
3. Connect the 2 way ABS pump motor connector to the EBCM (2).
4. Install BPMV (3) to EHCU bracket (5).
5. Connect the two electrical harness connectors to the EBCM (2).
Important: The brake pipes are held in the proper place by a frame mounted plastic bracket. Make sure that the brake pipes stay in the correct
place for proper reassembly.
6. Install the 5 brake pipes to the BPMV (3).
Tighten
Tighten the brake pipe fittings to 30 Nm (22 ft. lbs.).
7. Bleed the brake system. Refer to Automated Bleed Procedure.
8. Return to A Diagnostic System Check.
