Hombre S Space Cab 2WD V6-4.3L (2000)
5. Install the nut for the power steering pump rear bracket at the front of the engine.
Tighten the power steering pump mounting bracket bolts and the power steering pump rear bracket nuts to 41 Nm (30 ft. lbs.).
6. Install the AIR reactor pipe bracket nut to the power steering pump rear bracket front stud, if equipped.
Tighten the AIR reactor pipe bracket nut to 41 Nm (30 ft. lbs.).
7. Install the drive belt.
8. Install the fuel supply and return pipes to the rear of the intake manifold.
Important: In order to install the distributor for the correct engine timing, position the engine to number one cylinder top dead center.
9. Remove the spark plug for number one cylinder.
10. Rotate the crankshaft until number one cylinder is in the compression stroke.
11. Align the two reference marks on the crankshaft balancer (1) and (4) with the two alignment marks (2) and (3) on the front cover.
12. Install the spark plug.
13. Install the distributor.
14. Install the EVAP canister purge solenoid valve.
15. Install the EGR valve inlet pipe to the intake manifold and the exhaust manifold.
