Hombre S Space Cab 2WD V6-4.3L (2000)
Turn Signal Switch: Service and Repair
Tilt Column
On Vehicle
Removal Procedure
Caution: Refer to SRS Handling Caution in Service Precautions.
1. Disable the SRS system. Refer to Restraint Systems.
Ensure the turn signal lever on the multifunction switch is in the neutral position or the off position.
2. Remove the knee bolster.
3. Loosen the steering column bracket nuts.
4. Remove the steering column upper and lower trim covers.
5. Remove the 2 wire harness straps from the steering column wire harness.
6. Remove the connector position assurance (CPA) retainer from the auto trans shift lock control.
7. Disconnect the steering column bulkhead connector from the vehicle wire harness.
8. Disconnect the gray and the black connectors of the switch from the column bulkhead connector.
9. Remove the multifunction switch to the steering column mounting screws.
10. Remove the multifunction turn signal/hazard switch.
Installation Procedure
1. Install the multifunction turn signal/hazard switch.
^
Use a small blade screwdriver in order to compress the electrical contact.
^
Move the multifunction switch into the position.
^
Ensure the electrical contact rests on the canceling cam assembly.
Notice: Refer to Fastener Notice In Service Precautions.
2. Install the multifunction switch to steering column mounting screws.
