Hombre S Space Cab 2WD V6-4.3L (2000)
VCM/PCM Learn Timer
The scan tool displays the state of the VCM/PCM learn timer. The scan tool displays INACTIVE when the BCM is not in a learn mode.
VTD Fuel Disable
The scan tool displays the state of the VTD fuel disable mode. The scan tool displays INACTIVE when the Passlock(TM) system verifies a valid
password.
VTD Fuel Disable Until Ignition Off
The scan tool displays the state of the VTD fuel disable until Ignition off mode. The scan tool displays NO when the Passlock(TM) system verifies a
valid password.
VTD Password Learn Mode
The scan tool displays the state of the VTD password learn mode. The scan tool displays INACTIVE when the Passlock(TM) system is not in a learn
mode.
Without Scan Tool
You may NOT clear a DTC from the memory of the BCM by performing either of the following actions:
-
Disconnecting the battery
-
Disconnecting the BCM electrical connectors
Perform one of the following steps in order to clear a DTC from the memory of the BCM:
-
Use the scan tool.
-
Perform 100 concurrent ignition cycles without the fault recurring.
You must clear the DTCs from the BCM after performing a repair. You may also clear the DTCs from the BCM in order to ensure that a malfunction
will not occur again. If the fault still exists, the DTC will reset after clearing the DTCs. If any current non-Passlock (TM) system related DTCs exist,
diagnose those DTCs before clearing the Passlock (TM) DTCs. When the Passlock (TM) DTCs are cleared, the BCM DTCs will also be cleared.
With Generic Scan Tool
ISUZU does not provide a procedure for clearing diagnostic trouble codes with a generic scan tool.
With TECH 2
You may NOT clear a DTC from the memory of the BCM by performing either of the following actions:
-
Disconnecting the battery
-
Disconnecting the BCM electrical connectors
Perform one of the following steps in order to clear a DTC from the memory of the BCM:
-
Use the scan tool.
-
Perform 100 concurrent ignition cycles without the fault recurring.
You must clear the DTCs from the BCM after performing a repair. You may also clear the DTCs from the BCM in order to ensure that a malfunction
will not occur again. If the fault still exists, the DTC will reset after clearing the DTCs. If any current non-Passlock (TM) system related DTCs exist,
diagnose those DTCs before clearing the Passlock (TM) DTCs. When the Passlock (TM) DTCs are cleared, the BCM DTCs will also be cleared.
