Hombre S Space Cab 2WD V6-4.3L (2000)
CAUTION: In order to reduce the risk of fire and personal injury that may result from a fuel leak, always replace the fuel sender gasket
when reinstalling the fuel sender assembly.
1. Install the new seal on the fuel tank.
Important: The fuel strainer must be in a horizontal position when the fuel sender is installed in the tank. When installing the fuel sender
assembly, assure that the fuel strainer does not block full travel of the float arm.
2. Install the fuel sender assembly into the fuel tank.
NOTE: Refer to the Fastener Note in Service Precautions.
3. Install the fuel sender assembly retaining ring using the J 39765 Fuel Sender Lock Nut Wrench.
4. Install the fuel tank.
5. Refill the fuel tank.
6. Tighten the fuel filler cap.
7. Connect the negative battery cable.
8. Inspect for leaks.
1. Turn ON the ignition for 2 seconds.
2. Turn OFF the ignition for 10 seconds.
3. Turn ON the ignition.
4. Inspect for fuel leaks.
