Hombre S Space Cab 2WD V6-4.3L (2000)
4. Disconnect the HO2S harness connector. The harness connector may typically have either a 1x4 or 2x2 configuration.
5. Use the J 39194 in order to remove the HO2S.
Installation Procedure
Important: A special anti-seize compound is used on the heated oxygen sensor (HO2S) threads. The compound consists of liquid graphite and glass
beads. The graphite tends to burn away, but the glass beads remain, making the sensor easier to remove. New, or service replacement sensors already
have the compound applied to the threads. When installing a previously removed sensor, the threads must have anti-seize compound applied before the
installation.
1. Coat the threads of the oxygen sensor with anti-seize compound or the equivalent if necessary.
NOTE: Refer to Component Tightening Notice in Service Precautions.
