Hombre S Space Cab 2WD V6-4.3L (2000)
Reminder Calibration Number
The scan tool displays the reminder warning calibration part number in the BCM.
Reminder Suffix
The scan tool displays the reminder warning identification number in the BCM.
Retained Accessory Power (RAP) Calibration Number
The scan tool displays the RAP calibration part number in the BCM.
Retained Accessory Power (RAP) Suffix
The scan tool displays the RAP identification number in the BCM.
Security Calibration Number
The scan tool displays the security calibration part number in the BCM.
Security Suffix
The scan tool displays the security identification number in the BCM.
Data
Ambient Light
The scan tool displays LIGHT when the ambient light sensor voltage is between 2.2 - 4.7 volts. The scan tool displays DARK when the ambient light
sensor voltage is between 0.2 - 1.3 volts.
Ambient Light Sensor
The scan tool displays the output voltage of the ambient light sensor based on the intensity of light detected. As the light intensity increases, the sensor
displayed voltage increases. In the LIGHT state, a high voltage (2.2 - 4.7 volts) is present and the DRL will be ON. In the DARK state, a low voltage (
0.2 - 1.3 volts) is present and the headlamps will be ON.
Battery Voltage
The scan tool displays the battery system voltage.
Courtesy Lamp Timer
The scan tool displays the seconds left before the BCM turns the courtesy lamp relay OFF. The BCM uses this feature to control the components
attached to the illuminated entry, the remote illuminated entry and the exit lighting circuits.
Dimming Potentiometer
The scan tool displays the voltage value indicating the position of the dome lamp switch (thumbwheel). The scan tool displays 0 (zero) volts when the
headlamp switch is in the AUTO position and the daytime running lamps (DRL) are ON. The scan tool displays 10.5 volts when either the park lamps or
the headlamps are turned ON and the dome lamp switch is in the FULL BRIGHT position.
High Beam Input
The scan tool displays the voltage in order to determine the state of the high beam headlamps. The scan tool displays 12.2 volts with the low beams ON
and 0.8 volts with the high beams ON.
Inadvertent Power Timer
The scan tool displays the seconds left before the BCM turns the inadvertent power relay OFF. The BCM uses this feature to protect the battery against
inadvertent battery rundown caused by components that are part of the courtesy lamp circuit. The inadvertent power relay is supplied power by the BCM
for 2400 seconds (approximately 40 minutes), after the ignition is turned OFF.
Retained Accessory Power (RAP) Timer
