Hombre S Space Cab 2WD V6-4.3L (2000)
1. Install the SDM (2) to the vehicle (3).
NOTE: Refer to Fastener Notice in Cautions and Notices.
2. Install the SDM mounting fasteners (1).
Tighten
Tighten fasteners to 12 Nm (106 lb in).
3. Install the SDM harness connector to the SDM.
4. Install the connector position assurance (CPA) to the SDM harness connector.
5. Position the carpet to cover the supplemental restraint sensing and diagnostic module (SDM).
6. Install the LH kick panel. Refer to Door Sill Plate Replacement.
7. Install the floor console (if equipped), Refer to Console Replacement - Front Floor in Instrument Panel, Gauges and Console.
8. Install the LH carpet retaining sill trim molding. Refer to Door Sill Plate Replacement in Interior Trim.
9. Install driver seat belt to floor. Refer to Seat Belt Replacement - Front.
10. Install the driver seat. Refer to Seat Replacement - Bench or Seat Replacement - Bucket in Seats.
11. Enable the SRS.
