Hombre S Space Cab 2WD V6-4.3L (2000)
WARNING: If an airbag (or Seat Belt Tensioner) cannot be deployed, it should not be treated as normal scrap; it should still be considered a
potentially explosive device that can cause serious injury.
Special Procedure For Damaged Airbag
1. If installed in a vehicle, follow the removal procedure.
2. In all cases, make a short circuit by twisting together the two airbag inflator wires.
3. Package the airbag in exactly the same packaging that the new replacement part came in.
4. Mark the outside of the box "DAMAGED AIRBAG (or TENSIONER) NOT DEPLOYED" so it does not get confused with your parts stock.
5. Contact your Isuzu District Service Manager for how and where to return it for disposal.
Removal and Installation
Removal Procedure
CAUTION: When you are performing service on or near the SRS components or the SRS wiring, you must disable the SRS system. Refer to Disabling
the SRS. Failure to follow the correct procedure could cause air bag deployment, personal injury, or unnecessary SRS repairs.
CAUTION: Refer to SRS Handling Caution in Cautions and Notices.
1. Disable the SRS system.
2. Turn the ignition switch to the ON position to unlock the steering wheel.
3. Turn the steering wheel 90 degrees from the straight-ahead position in order to gain access to the access holes behind the steering wheel.
4. Insert a screwdriver into each access hole and push the leaf spring to release the pin that retains the inflator module.
