Hombre S Space Cab 2WD V6-4.3L (2000)
5. Drill out the mounting rivets.
IMPORTANT: The following procedures should be utilized in the event that sensor mounting holes or fasteners are damaged to the extent that
the sensor may no longer be properly mounted.
6. Remove the supplemental restraint front end discriminating sensor from the vehicle.
7. Perform the following steps in order to complete the first fastener repair:
1. Remove and discard the improperly installed rivet.
2. Reattach the sensor with new rivet.
8. Perform the following steps in order to complete the second fastener repair:
1. Remove the improperly installed rivet.
2. Enlarge the mounting holes in the lower radiator support to 9.0 mm (0.35 in).
3. Insert and properly seat the rivnut.
NOTE: Refer to Fastener Notice in Cautions and Notices.
4. Install sensor with screw.
Tighten
Tighten fasteners to 8.0 Nm (71 lb in).
Installation Procedure
