Hombre S Space Cab 2WD V6-4.3L (2000)
5. Remove the 2 pan head tapping screws (1) from the turn signal and multifunction switch assembly (2).
6. Remove the turn signal and multifunction switch assembly (2) from the steering column tilt head assembly.
Assembly Procedure
1. Install the turn signal and multifunction switch assembly (2) onto the steering column tilt head assembly.
Notice: Refer to Fastener Notice In Service Precautions.
Important: The electrical contact of the turn signal and multifunction switch assembly (2) must rest on the turn signal cancel cam assembly.
2. Screw the 2 pan head tapping screws (1) into the turn signal and multifunction assembly (2).
Tighten
Tighten the 2 pan head tapping screws to 7 Nm (62 inch lbs.).
3. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).
