Hombre S Space Cab 2WD V6-4.3L (2000)
Ignition Switch Lock Cylinder: Service and Repair
Standard Column
Removal Procedure
Caution: Refer to SRS Handling Caution in Service Precautions.
1. Disable the SRS system. Refer to Restraint Systems.
2. Remove the upper and lower steering column trim covers.
3. Turn the ignition lock cylinder to the start position.
4. Using an awl, insert the tip into the ignition lock cylinder access hole (1).
5. Push down and hold the ignition lock cylinder retaining pin.
6. Release the ignition lock cylinder to the run position.
7. Remove the ignition lock cylinder by pulling the ignition lock cylinder away from the steering column (2).
Installation Procedure
1. Install the ignition lock cylinder to the steering column (2) by performing the following procedure:
1. Align the positioning locking tab slot on the lock module assembly to the positioning tab on the ignition lock cylinder.
2. Push the lock cylinder in until the locking tab locks in the lock module assembly.
2. Install the upper and lower steering column trim covers.
3. Enable the SRS system.