Hombre S Space Cab 2WD V6-4.3L (2000)
3. Install the adapter and bearing assembly (1) onto the steering column jacket assembly by performing the following steps:
1. Align the tab on the adapter and bearing assembly (1) with the slot in the steering column jacket assembly.
2. Push the adapter and bearing assembly (1) onto the steering shaft assembly until the tab snaps into the slot.
4. Install the shaft seal retainer (2) onto the adapter and bearing assembly (1).
1. Align the slots of the shaft seal retainer (2) to the ribs of the adapter and bearing assembly (1).
2. Push the shaft seal retainer (2) onto the steering shaft assembly so that the shaft seal retainer (2) contacts the adapter and bearing assembly (1).
5. Install the steering shaft seal (3) onto the steering shaft assembly.
6. Install the inner boot seal (4) onto the steering shaft assembly.
Important: The electrical contact of the turn signal and multifunction switch assembly (2) must rest on the turn signal cancel cam assembly.
7. Install the turn signal and multifunction switch assembly (2) onto the steering column housing assembly.
8. Screw the 2 pan head tapping screws (1) into the turn signal and multifunction switch assembly (2).
Tighten
Tighten the 2 pan head tapping screws to 7 Nm (62 inch lbs.).
9. Install the lock module assembly.
Column Shift
Disassembly Procedure
1. Remove the lock module assembly.
2. Inspect the steering column for accident damage.
