Hombre S Space Cab 2WD V6-4.3L (2000)
Installation Procedure
Tools Required
^
J 22269-1 Tie Rod End Installer
1. Install the upper control arm shaft to the upper control arm.
2. Install the control arm bushings to the upper control arm. Use the J 22269-1 and a short piece of pipe that is the same outer diameter as the rubber
bushing.
Tighten J 22269-1 until the bushing is positioned on the shaft and the upper control arm.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the washers and the nuts to the upper control arm shaft.
