Hombre S Space Cab 2WD V6-4.3L (2000)
8. Lower the vehicle.
Shackle Bushing Replacement
Removal Procedure
Tools Required
J 21474-01 Control Arm Bushing Service Kit
1. Raise and suitably support the vehicle.
2. Support the rear axle.
3. Remove spare tire.
4. Disconnect rear exhaust hangers and lower exhaust system, if necessary.
5. Remove the following parts:
^
The frame to spring shackle nut
^
The washers
^
The frame to spring shackle bolt
6. Loosen the lower spring shackle bolt at the leaf spring. Leave the bolt attached.
7. Lower the axle until there is enough clearance to remove the spring shackle bushing.
8. Use a blunt punch to straighten out the bushing flange that comes through the inner frame.
9. Remove the spring shackle bushing using J 21474-01.
10. Repeat steps 5 through 9 for other spring shackle bushing.
Installation Procedure
Tools Required
J 21474-01 Control Arm Bushing Service Kit
1. Install the new spring shackle bushing using J 21474-01.
2. Pull the bushing into the frame rail until the flanged portion of the bushing is flush with the rail.
3. Stake the spring shackle bushing inner flange.
4. Raise the axle into position.