Hombre S Space Cab 2WD V6-4.3L (2000)
14. Adjust the park lock cable assembly.
1. Use the shift lever clevis to put the column in the park position.
2. Put the ignition switch in the off-lock position. Remove the key.
3. Unlock the adjuster ring (1) on the park lock cable assembly with J 41396.
4. Pull on the cable until the park lock latch contacts the shift lever clevis.
Release the cable.
5. Lock the adjuster ring (1) securely in place on the park lock cable assembly with J 41396.
15. Inspect the park lock cable assembly.
1. Put the lock cylinder in the off-lock position. The shift lever clevis should not be able to shift out of the park position.
2. Turn the key to the run position and put the shift lever clevis in the neutral position.
3. With the shift lever clevis in the neutral position the lock cylinder should not be able to go into the off-lock position.
4. Put the shift lever clevis into the park position.
5. Put the lock cylinder in the off-lock position and then remove the key.
16. Install the automatic transmission shift lock actuator.
17. Enable the SRS system. Refer to Restraint Systems.
Disassembly and Assembly
Disassembly Procedure
Tools Required
J 41396 Park Lock Cable Pliers
1. Remove the upper and lower shrouds.
2. Remove the electrical BTSI actuator from the steering column.
3. Use a small screwdriver to pry the electrical BTSI actuator from the steering column jacket assembly.
