Hombre S Space Cab 2WD V6-4.3L (2000)
5. Position the tool J 41364-a onto the park/neutral position switch. Ensure that the two slots on the switch where the manual shaft is inserted are
lined up with the lower two tabs on the tool.
6. Rotate the tool until the upper locator pin on the tool is lined up with the slot on the top of the switch.
^
Tighten the bolts securing the switch to 25 Nm (18 ft. lbs.).
7. Remove J 41364-a from the switch.
8. Install the wiring harness connector at the vehicle harness.
9. Install the transmission control lever to the manual shaft with the nut.
^
Tighten the control lever nut to 25 Nm (18 ft. lbs.).
10. Lower the vehicle.
11. Check the switch for proper operation. The engine must start in the P (Park) or N (Neutral) positions only. If adjustment is required.
