Hombre S Space Cab 2WD V6-4.3L (2000)
10. Remove the pinion flange using the J 8614-01. Use a container in order to retrieve the lubricant.
Installation Procedure
^
Tools Required
-
J 8614-01 Companion Flange Holder
1. Apply sealant to the inside sealing surface of the pinion yoke.
2. Apply a seal lubricant to the outside of the pinion flange.
Important: Do not hammer the pinion flange onto the pinion stem.
3. Install the pinion flange.
4. Install the washer and a new nut.
^
Tighten the nut on the pinion stem as close to the original marks as possible without turning the nut past the mark. Use the reference mark and
the thread count as a reference. Tighten the nut slightly. Turn the pinion flange several times after each tightening in order to set the rollers.
Important: If the original preload torque value was less than 0.34 Nm (3 inch lbs.), reset the torque specification to 0.34 - 0.56 Nm (3 - 5 inch
lbs.).
